On the Drager Fabius trio, when the breathing pressure goes above the set threshold for more than 15 seconds, what should your first step be?On the Drager Fabius Trio, if the set pressure is not achie

1. On the Drager Fabius trio, when the breathing pressure goes above the set threshold for more than 15 seconds, what should your first step be?
2. On the Drager Fabius Trio, if the set pressure is not achieved while ventilating in pressure control mode what should you do?
3. On the Drager Fabius Trio, the Peep is 4 cmH2O above the Peep setting in an automatic ventilation mode. What steps should you take?
4. On the Drager Fabius Trio, the O2 supply line has less than the minimum pressure permitted (approximately 20 psi). What steps should you take to resolve the issue?
5. On the Mindray A5/A3, what is the part number for the gasket, C02 bypass assembly. Also, when should the gasket be replaced and checked?
6. On the Mindray A5/A3, during the leak test the pressure indicated by the airway pressure gauge fails to reach 30 cmH20. What should you check?
7. On the Mindray A5/A3 a common problem is Calibration failure. It is prompted about 3 minutes after the calibration is started. What steps should take to resolve the issue?
8. On the Mindray A5/A3 what are the functional tests done on this unit prior to surgical use?
9. With the Datex-Ohmeda Aestiva/5 what are some of the service tools required for testing?
10. On the Datex-Ohmeda Aestiva/5 what are the steps when replacing the 4thand 5thgas cylinder supply module?
11. On the Datex-Ohmeda Aestiva/5, what are the steps for the 6, 12, and 24 months planned maintenance?